Professional Mixing Guide

Always pretest for color fastness. For easier mixing: Slowly pour measured powder INTO warm or cold water of a bucket or jug, then stir it around with a stick until dissolved.

In-Line Sprayer: For easier mixing, meter at 1:4 ratio (remove 1:8 yellow tip) and use 6 scoops (12 ounces) per 5 quart container. Otherwise, if using 1:8 yellow tip, use 12 scoops (24 ounces) per 5 quart container.

Carpet: 2 scoops (4 ounces) per Gallon. 
1) Slowly pour powder INTO water. Shake if necessary to dissolve. 2) Pre-spray evenly on carpet paying particular attention to heavy traffic areas, stains, grease, etc. Spray at a rate of about 1 gallon per 300 sq/ft. 3) Best to agitate with rake, bonnet, crb, etc. 4) Let dwell 5 to 10 minutes (its ok if it dries before getting to it). 5) Extract with plain cold or hot water through wand.  It is not required to extract 100% since whatever is left will continue to encapsulate and clean. 6) No acid/neutralizing rinse required.​

Tile and Grout and hard surfaces:  2 scoops (4 ounces) per Gallon
1) Slowly pour powder INTO water. Shake if necessary to dissolve. 2) Spray/apply onto floor. 3) Let dwell for at least 5 to 10 minutes (it is okay if it dries before cleaning off). 4) Re-wet with water as you scrub and extract with mop, spinner, wet/dry, hose rinse, etc.

Upholstery:   1 scoop (2 ounces) per Gallon
1) Slowly pour powder INTO water. Shake if necessary to dissolve. 2) Spray lightly directly onto upholstery or onto a towel. 3) Agitate with soft bristle brush or clean towel. 4) No extraction required.

Urine stains & odor:   2 scoops (4 ounces) per Gallon
1) Clean carpet according to instructions for carpet above, 2) Post spray Carpet Details at rate of 1 gallon per 500 sq/ft, do not extract this time, 3) If desired, spray a deodorizer in the area to cover up the odor that gets kicked up. As the Carpet Details dries in the carpet it will kill the urine and odor molecules permanently. 

Encapsulation & Low Moisture:   2 scoops (4 ounces) per Gallon
Bonnet and OP (Oscillating Pad) cleaning:
1) Pre-spray evenly on carpet paying particular attention to heavy traffic areas, stains, grease, etc. Spray at a rate of about 1 gallon per 300 sq/ft. 2) Let dwell 10 minutes on greasy areas and high traffic areas. 3) Agitate product into the carpet while lightly rewetting carpet using damp bonnet pads (using a solution tank on floor machine with clean water increases speed dramatically). 4) Use multiple pads to pad out grease areas. 

CRB machines with NO solution tank (Brush Pro, etc):
1) Pre-spray evenly on carpet paying particular attention to heavy
traffic areas, stains, grease, etc. Spray at a rate of about
1 gallon per 300 sq/ft.  2) While carpet is still damp,
agitate product into the fibers with CRB machine.

Machines WITH solution tanks (Cimex, Multiwash, etc):
1) Apply evenly on carpet through machine’s system paying 
particular attention to heavy traffic areas, stains, grease, etc.
2) Apply at a rate of about 1 gallon per 300 sq/ft.